A before and after of the high detail stainless steel 3d print from imaterialise. I don't think they polished it at all.
As you can see it is possible to buff it up, seen on the right on the calibration sprue.
Tuesday, 17 September 2013
Custom Pandora Charm
After much polishing and a blackened cavity pass this is starting to look a bit more like a proper charm. The weight is completely different however. Not something I'm going to do anything about.
A before and after of the high detail stainless steel 3d print from imaterialise. I don't think they polished it at all.
As you can see it is possible to buff it up, seen on the right on the calibration sprue.
A before and after of the high detail stainless steel 3d print from imaterialise. I don't think they polished it at all.
As you can see it is possible to buff it up, seen on the right on the calibration sprue.
Subscribe to:
Post Comments (Atom)
1 comment:
What is the measurements of the inside hole and thread (for those looking to create our own beads)?
Post a Comment